Measurement (Overlays)

Face Centerpoint (Overlays)

Estimated reading: 2 minutes 420 views

In Blender, we can turn on measurements in Edit Mode. This is done by clicking on the Mesh Edit Overlays button. 

When Center is clicked within this overlay panel, we’ll see a dot on both selected and inactive faces. This can be useful when working with complex meshes, but it can also be used to detect N-gons (mesh topology).

Offset Face Centerpoint (N-gons)

N-gons are a common issue that can affect UV mapping when working with meshes. It may also affect how material maps are displayed on a mesh surface. In the image below, we see that the face centerpoint is offset.

The active white dot is not in the middle like in the face to the right. This indicates that this face is an N-gon because no edges have been added to connect the vertices at the top.
To correct this, we can subdivide the edges of this N-gon, or triangulate the face using the shortcut Ctrl + T.

With the triangulation method, we can change the N-gon Method to Clip, for example. But this one will not connect all the vertices, so it’s up to you to choose between those two to make the N-gon into triangles, unless you want to make quads instead (edge subdivision).

Mesh topology is a vast topic, so displaying these centerpoints may be helpful.